ENS1200/ENS1750 WDS Bridge connection goes to "sleep"

Issue: ENS1200 and/ ENS1750 WDS Bridge to WDS Bridge link disconnects or does not pass traffic after a period where the link was idle or inactive.

Fix: Update the firmware of the ENS1200/ENS1750. After a successful update, it is recommended to reset the ENS1200/ENS1750 back to factory default then set it up again. Please do not use a backup configuration file to set up the ENS1200/ENS1750 specially one that was saved while on a different firmware version.

ENS1200: https://www.dropbox.com/s/ez2qhh7y45xp4o1/ens1200-fcc-v2.0.208.0.bin?dl=0

ENS1750: https://www.dropbox.com/s/qvbxm6wbiu1izss/ens1750-fcc-v2.0.180.0.bin?dl=0

Check out EnGenius Forum about similar topic:

http://community.engeniustech.com/topic/730-ens1200ens1750-wds-bridge-connection-goes-to-sleep

Articles in this section

Comments

Articles in this section

Related articles