Accessing the CLI
The Switch’s serial port’s default settings are as follows:
- 115200 baud
- no parity
- 8 data bits
- 1 stop bit
- Flow Control: None
A computer running a terminal emulation program capable of emulating a VT-100 terminal and a serial port configured as above are then connected to the Switch’s Console port.
With the serial port properly connected to a management computer, press the Enter key and enter the username and password.
Figure 1: EGS7228FP switch
Figure 2: sample of PuTTY client
Check out EnGenius Forum about similar topic:
Please sign in to leave a comment.