This article will show you how to use bulk update on ezMaster software.
Please make sure that you have the ezMaster installed and active/running on a host computer.
Open your web browser (i.e. Internet explorer, Google Chrome, Mozilla Firefox)
Type the IP address of the ezMaster to the address bar of your web browser. Type the login credentials you created upon installing the ezMaster software.
#1 Click on the Project”
#2 Click Bulk Update (Under Maintenance)
Please make sure that you have the RAW Firmware file saved on a host computer.
#3 Click Upload File
#4 Click Choose file and locate the RAW firmware that you saved on the host computer
#5 Click Apply to upload the RAW firmware file to ezMaster Software
#6 Click OK once the upload is completed.
(You can also upload firmware for more than one AP model and have it available within ezMaster.)
#7 Select the correct firmware file and the access point/s respectively and click Add to Upgrade
#8 Wait for the firmware to upload to the Access Points
Note: The above also applies to Bulk Update (Switch)