The Wireless MAC address filter is a feature available on Neutron wireless access points when running in standalone mode. (When the AP is managed by a controller or ezMaster, this is done by banning clients on the controller, which automatically populates the MAC address filter to deny those client device MAC addresses on all managed APs on the network.)
The MAC address filter can be set up per SSID and has a limit of 32 entries per SSID. The MAC filter mode on each SSID can be set to either block certain wireless devices or allow only certain wireless devices to connect to the SSID. It is not possible to simultaneously have a MAC address filter “block” list and an “allow” list on an SSID.
- On the GUI, go to Network and select Wireless. Click on the Edit button of the SSID where the MAC filter will be enabled.
- Select the ACL mode whether to allow or deny wireless clients on the list to connect to the SSID.
- Type in the wireless MAC address of the wireless device that will be blocked/allowed and click on ADD.
- Click on SAVE. Click on CHANGES then APPLY.
EnGenius Community Forum Link:
Comments
2 comments
ank you so much for this. I was into this issue and tired to tinker around to check if its possible but couldnt get it done. Now that i have seen the way you did it, thanks guys
with
regards
https://www.ucbrowser.vip/ https://shareit.onl/ https://mxplayer.pro/
Hi! I could have sworn I've been to this site before but after going through some posts I realized it's new to me. However, I'm sure glad I found play snake en and check back!
Please sign in to leave a comment.