Articles in this section
- Outdoor RSSI and Acceptable Signal Strength
- How to optimize wireless bridge after deployment?
- Why can’t I add my ENS620EXT as a managed AP on my Neutron switch?
- Can I set up 2 pairs of EnStationAC bridges as LAG links?
- Pole and Wall mounting EnStation2/5/5-AC/AC
- What is the peak power consumption of EnTurbo outdoor AP/Bridges?
- How to set up Auto Reboot on 802.11ac Electron APs
- Why can’t I factory reset the ENS1750 via hardware reset button?
- What is Layer 2 Isolation? Does it block the communication from wireless clients to wired clients/devices?
- What is the difference between Mesh AP and Mesh Point?
Comments
2 comments
I go to wds link status I see them then one goes off line reset both they are back up go back and check then a different one goes off line. then reset it and they are back online for a bit but not passing traffic. reset both they stay on for a bit then a different one goes offline. Is there a different setting or a limit on bridge mode?
I have been having this same issue. Did you find a solution? I have gone through all of the steps and I cannot get both devices to link with one another at the same time. I am factory resetting and going through the set up process again to see if I missed something.
Please sign in to leave a comment.