
EnGenius Admin
- Total activity 970
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 1
- Subscriptions 500
Articles
Recent activity by EnGenius Admin Sort by recent activity-
EnGenius AP Configuration Best Practices
This document provides guidelines on best practices for configuring EnSky access points, along with guidelines to select the best access point models for particular applications. Application Guid...
-
Since static IP addressing is recommended in most access point deployments, is it okay if I set my access point to obtain an IP address and reserve it on the router setting?
When assigning static IP addresses, you want to assign them outside the DHCP lease pool, and that generally means excluding a portion of the range from the DHCP pool. If you assign a local static I...
-
Can I connect non-PoE devices to the PoE switch's PoE ports?
Yes, you can. All EnGenius PoE switches have auto-sensing PoE ports. This means that the PoE port will detect if the connected device is a PoE device or not. Please check if the PoE device is 802.3...
-
Can I change the router login username to something other than “admin”?
Yes, the router login username can be changed. Steps: Access the setup page using a browser. Use the IP address set for the router. The default IP address is 192.168.0.1. Enter the username and ...
-
What is the default IP, username and password for EnGenius devices?
Default Settings IoT Gateways and Routers Access Points Managed Switches IP Cameras Managed Access Points (Neutron) IP Address 192.168.0.1 192.168.1.1 192.168.0.239 If connected to a DH...
-
Is there a length limit to PoE cable runs?
Yes. Yes, Power over Ethernet (PoE) will will only power the unit so long as there is enough voltage to power the unit at the end of the cable run. The maximum distance you can power a device will ...
-
What is RSSI and its acceptable signal strength?
RSSI stands for Received Signal Strength Indicator. It is an estimated measure of power level that an RF client device is receiving from an access point or router. At larger distances, the signal g...
-
Can the EnGenius VMS be used for the initial configuration of the EDS5110?
No, the EDS5110 should already be configured and integrated to the network before adding it to the Video Management System (VMS). It is recommended to use the EnViewer Finder for the initial setup....
-
Why can’t I factory reset the ENS1750 via hardware reset button?
A feature called “User Setting” in several Electron models where the factory default settings can be overwritten with the current AP settings. This was included based on a specific customer reques...
-
What is the difference between Mesh AP and Mesh Point?
Neutron firmware code c1.8.53 (and later) supports Mesh feature for Neutron Access Points. Mesh provides a network topology in which remote nodes relay data for the network wirelessly (i.e. withou...